The unit will operate as notmal and will power ON and OFF withthe application of the external power source.NOTE: If the external power source is removed from the unit while in the manual override or “OFF”mode, the unit will automatically turn on when the external power is again applied. Press and release any button (either UP or DOWN).2. The manual override is now set.To remove the Manual Override:1. Release the buttons and the unit will continue to display “OFF” signifying no depth readings will bedisplayed nor will any depth alarms be active.4. After 6 seconds the unit will display “OFF”.3. With the unit on, press and hold both the UP andDOWNbuttons for 6 seconds.2. This is especially helpful when there is not a switched external power sourceavailable to the unit, or the user wishes to turn the unit OFF to prevent interference with other sonarequipment on the vessel.To set the Manual Override:1. Contact Technical Support at 94 for assistance if you are unable to correct the problem.POWERING ON & OFFUnder normal operation the unit will turn on and off with the external power supply (key switch).MANAUL POWER OVERIDEThe manual power override allows the user to turn the unit OFF with the presence of a constant externalpower source (key switch on). Make sure that the connection is made as per theinstructions in the Connecting the Transducer section of this manual.6. Check the transducer cable connection on the back of the display. If this happens frequently makesure that the trailer or boat lift supports do not interfere with the transducer during loading and unloading.5. If this occurs referto the Transducer Installation Instructions to reset the transducer for normal operation. To prevent damage tothe transducer, it will automatically release from the mounting bracket (kick-up) when it is impacted. If the transducer is transom mounted check to make sure that the transducer is not “kicked-up”. Pleaserefer to the Transducer Installation Instructions to minimize the effects of these conditions.4. Extremely dirty water, very soft bottom,high speeds, deep water, or a combination of the above may result in incomplete or inaccurate readings. Under certain circumstances the display may not perform at the best of its ability. Refer to the Transducer Installation Instructions for adjustment procedures.3. Refer to the “Helpful Hints forTransducer Installation” section below. If this condition occurs only at certain speeds, then a transducer adjustment is needed. Operate the display under normal operating specifications andcheck to see if it operating properly.2. The depth is less than 2.5 feet or greater than 200 feet. The Bottom Reading is Random, Flashing, or Appears as “-” on the Display.1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |